Stone Chip Protection - Grey
An under-body high solids and low viscosity non-bitumen based stone chip. Excellent anti-corrosive properties and some sound deadening characteristics. Contains Xylene.
A tough, flexible corrosion and chip resistant coating for all-round protection and sound deadening qualities. Suitable for all lower body panels vulnerable to stone chips. Stonechip is not suitable for use on synthetic painted surfaces. .
Directions For Use
Shake can thoroughly before use. Minimum of two minutes.
Spray at a pressure of 40/80 p.s.i and at a distance of 30-45 cm.
Stonechip when fully cured may be overcoated with compliant refinishing paint systems.
Always ensure the surface to be treated is suitably prepared, and fully degreased with Tetrosyl Panel Wipe. Check that the spray gun is clean and free from blockages ( excess pressure may cause the can to burst.)
Coverage
Approximately 8 square metres per litre.
Cleaning
Tetrosyl Gun Wash
Storage
This product is subject to regulations governing the storage of highly flammable liquids and liquefied petroleum gases.
Safety
See separate Material Safety Data Sheet (MSDS)
